MIL-I-60513A
however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Materials. All materials used in the manufacture of the initiators shall conform to the specifications referred to on the respective drawings unless specific approval in writing coveringa departure therefrom has been obtained from the cognizant Navy design activity prior to manufacture. When alternate materials or methods of manufacture are specified on the drawings, the bidder's selections shall be clearly stated in the proposal.
3.2 Conformance to documents. The M45A1 initiator covered by this specification shall be manufactured in accordance with DL8596101.
3.3 Components.
3.3.1 Primary components. For the purpose of this specification, the M114 delay cartridge (Drawing8596110)isdefinedasaprimarycomponent. Onlyprimarycomponentsfromasinglelot shallbeusedinaproductionlotofinitiators;however,oneprimarycomponentproductionlotmay be used in more than one initiator production lot.
3.3.2 Component parts. AllcomponentpartsshallmeettheapplicablerequirementsofMIL-I-
46497 or MIL-I-14804 prior to assembly.
3.4 Initiator pin security. Application of an axial load of 200 to 220 pounds to the initiator pin of the assembled initiator shall not withdraw the initiator pin past the safety pin. Load application shall cause no permanment deformation of the safety pin (see 4.3.1).
3.5 Breakaway torque. The chamber and cap of each assembled initiator shall withstand a breakaway torque application of 400 inch-pounds without loosening or deformation (see 4.3.2).
3.6 Residual magnetism. The initiator shall not deflect the indicator of the compass more than 3 degrees in either direction when passed in front of the compass at a distance of 6 inches (see 4.3.3).
3.7 Radiographic examination. Each initiator assembly shall be radiographically examined for defects (see 4.3.4).
3.8 Functional.
3.8.1 Ballistics. Initiators loaded with cartridges and temperature conditioned shall perform within the pressure values specified in table I. Pressure values shall be recorded at the endof3feetofaircrafthose,assemblynumberMS28741-4,andapressurechamberwithavolume of
1 cubic inch.
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business