MIL-DTL-60515C
4.5.1.2 Size of lot. For the purpose of identification and shipment, the shipping lots of metal parts
assemblies shall consist of 600 assemblies, maximum, unless otherwise specified by the contract.
4.5.2 Examination. One hundred percent examination shall be performed for all critical defects.
Examination for major and minor defects shall be performed on a defect basis in accordance with the
classification of defects. Four power (4x) magnification may be used in performing visual examination for
such defects as burr and foreign matter. Inspection for rubber O-rings shall be in accordance with MIL-
STD-413. When compliance with the applicable requirement is in doubt as a result of visual examination,
the characteristic shall be measured or gaged to determine acceptability. All nonconforming material shall
be rejected.
4.5.2.1 Retainer, Cartridge, Drawing 8594860, covering a detail of Drawing 10520225.
Characteristics
Defect
Method of Inspection
Critical
1
Metering slots in base missing
Visual
Major
101
Pitch diameter of thread, max
Gage
102
Minor diameter of thread, max
Gage
103
Concentricity of cavity with pitch diameter of thread
Gage
104
Concentricity of counterbore with cavity
Gage
105
Perpendicularity of pitch diameter of thread with base
Gage
106
Symmetry of metering slots in base with body
Gage
107
Diameter of cavity, max
Gage
108
Depth of cavity
Gage
109
Depth to bottom of counterbore
Gage
110
Depth of metering slots in base
Gage
111
Length of effective thread, min
Gage
112
Length of thread, max
Gage
113
Internal radius at mouth cavity
Gage
114
Total length
Measure
115
Width of metering slots in base
Measure
116
Drill point in base, max
Measure
117
Number of elongated slots incorrect
Visual
118
Thread damaged or not full
Visual
119
Metal defective
Visual
120
Protective finish inadequate or defective
Visual
121
Surface finish on internal radius and base improper
Visual
122
Burr
Visual
123
Foreign matter
Visual
Minor
201
Pitch diameter of thread, min
Gage
202
Diameter of cavity, min
Gage
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business