MIL-DTL-60515C
porosity, or any similar defect.
3.10.2 Burr. No part shall have a burr which might interfere with the assembly or function of the
item or which might be injurious to personnel handling the item.
3.10.3 Foreign matter. No part or assembly shall contain chips, drt, grease, rust, corrosion, or
i
other foreign matter.
4. VERIFICATION
4.1 Classification of inspections. The inspection requirements specified herein are classified as
follows:
a.
First article inspection (see 4.4)
b.
Quality conformance inspection (see 4.5)
4.2 Quality assurance terms and definitions. Reference shall be made to ANSI/ASQ A8402 to
define the quality assurance terms used.
4.3 Inspections. Inspections shall be in accordance with MIL-A-2550.
4.3.1 Inspection conditions. Unless otherwise specified (see 6.2), all inspections shall be
performed under the following conditions:
a.
Temperature: room ambient (68 to 77°F)
b.
Altitude: sea level
c.
Humidity: 50 percent relative, maximum
d.
Atmospheric pressure: 14.7 psi
4.4 First article inspection. At the beginning of regular production, the contractor shall submit an
initial production sample to a Government approved facility for evaluation. The sample shall consist of five
metal parts assemblies, nine sets of unassembled parts, and one set of unassembled parts without plating
or final protective finish. The sample shall be manufactured in the same manner, using the same materials,
equipment, processes, and procedures as used in regular production. All parts and materials, including
packaging and packing, must be the same as will be used for regular production and shall be obtained from
the same source of supply. After inspection and provisional acceptance at source, the first article sample
shall be inspected for all requirements of the drawings and specifications. The Government reserves the
right to require new first article samples until an acceptable sample is submitted (see 6.3).
4.5 Quality conformance inspection.
4.5.1 Lot.
4.5.1.1 Submission of product. Unless otherwise specified by the contracting activity, formation
and identification of lots shall be in accordance with ANSI/ASQ Z1.4.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business