MIL-DTL-60201D
3.7.6 Mechanical failures. The thruster shall function without mechanical failure (see 6.5.2).
3.8 Workmanship. Thrusters shall be free of cracks, splits, or other defects which might prevent
proper mating with connecting parts or proper functioning of the device.
3.8.1 Metal defects. All components shall be free from cracks, splits, cold shuts, inclusions, porosity,
or any similar defect.
3.8.2 Burr. No part shall have a burr which might interfere with the assembly or function of the item or
which might be injurious to personnel handling the item.
3.8.3 Foreign matter. No part or assembly shall contain chips, dirt, grease, rust, corrosion, or other
foreign matter.
4. VERIFICATION
4.1 Classification of inspections.
a. Quality conformance inspection
4.1.1 Quality assurance terms and definitions. Reference shall be made to ANSI/ISO/ASQ A8402 to
define the quality assurance terms used.
4.1.2 Inspections. Inspections shall be in accordance with MIL-A-2550 and ASTM E 1742.
4.2 Inspection provisions.
4.2.1 Lot.
4.2.1.1 Submission of product. Unless otherwise specified by the contracting activity, formation, and
identification of lots shall be in accordance with ANSI/ASQ Z1.4.
4.2.1.2 Size of lot. The production lot size shall be as specified in the contract (see 6.2).
4.2.2 Examination. One hundred percent examination shall be performed for all critical defects.
Examination for major and minor defects shall be performed in accordance with the classification of defects.
Four power (4x) magnification may be used for inspection of such defects as burr and foreign matter. When
compliance with the applicable requirement is in doubt as a result of visual examination, the characteristic
shall be measured or gaged to determine acceptability. All nonconforming material shall be rejected.
5
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business