MIL-DTL-50648B
4.8.1 Reconditioning. The sample must be tested within five minutes after removal from the
conditioning chamber. If this time is exceeded, the cartridge shall be reconditioned in accordance with
4.8.
4.9 Inspection of packaging. The sampling and inspection of the preservation, packing, and container
marking shall be in accordance with the requirements of section 5.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the contract
or order (see 6.2). When packaging of materiel is to be performed by DoD or in-house contractor
personnel, these personnel need to contact the responsible packaging activity to ascertain packaging
requirements. Packaging requirements are maintained by the Inventory control Point's packaging
activities within the Military Service or Defense Agency, or within the military service's system
commands. Packaging data retrieval is available from the managing Military Department's or Defense
Agency's automated packaging files, CD-ROM products, or by contacting the responsible packaging
activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful but is not
mandatory.)
6.1 Intended use. The assembly is used in cartridge actuated devices for Aircrew Emergency Escape
Systems. The assembly was developed for use in military aircraft and has no commercial applications.
6.2 Acquisition requirements. Acquisition documents should specify the following:
a. Title, number, date, and revision letter of this specification
b. Issue of DODISS to be cited in the solicitation and, if required, the specific issue of individual
documents referenced and that MIL-STD-810D shall be used (see 2.1, 3.5.2, and 4.7.4)
c. Whether a first article sample is required (see 3.1, 4.4, and 6.3)
d. Test facility for first article tests (see 4.4.1)
e. Production test activity and lot size (see 4.1 and 4.5.1.2)
f. Any special test conditions (see 4.3)
g. Directions for shipping radiographs of ignition devices and of entire lot of delay element
assemblies (see 4.7.1 and 4.7.3)
h. Directions for sampling for protective finish tests (see 4.7.2)
i. Level of preservation and packing (see 5.1 and 6.4)
12
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business