MIL-T-46691B
Major
None defined
Minor
201Contents looseVisual/Manual
202Strapping missing, loose, broken, or improperly assembled Visual/Manual
203Contents of box exposed Visual
204Box damaged Visual
205Marking missing, incorrect, or illegible Visual
206Number of units incorrect Visual
4.5.2.15 Box, Fiberboard (Outer), Alternative, Packing, Ammunition, Drawing 9217557.
Critical
None defined
Major
None defined
Minor
201Contents looseManual/Visual
202Carton broken or damageVdisual
203Number of units incorrect Visual
204Marking missing, incorrect, or illegible Visual
205Tape incomplete Visual
4.5.3 Inspection testing. The following tests shall be performed in accordance with 4.6.
4.5.3.1 Hardness. Fifty units from each heat treated lot of components shall be tested for compliance with the requirements on the applicable drawing. Failure of any unit to comply with the drawing requirements shall be cause for rejection of the lot of components.
4.5.3.2 Hydrostatic pressure. Each cylinder and head shall be subjected to the hydrostatic pressure test. Failure of any cap or chamber subassembly to comply with 3.4 shall be cause for rejection of the subassembly.
4.5.3.3 Fluid leakage. Each subassembly shall be subjected to a fluid leakage test. If an appreciableamountoffluidaccumulatesaftertheminimumtestperiod,theunitshallberejected. If after the minimum test period there is only a thin film of fluid covering the piston face, then
the piston face shall be wiped clean and the subassembly retested for another minimum period.
4.5.3.4 Presence of piston shear pin. Eachassembly shall be subjected to a test to determine the presence of a shear pin in the piston lock. Failure of any unit to comply with the requirements of 3.6.3 shall be cause for rejection of the unit.
15
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business