MIL-T-46605 Thruster, Cartridge Actuated, M13 Metal Parts AssemblyThis specification covers the requirements for the M13 Cartridge Actuated Thruster Metal Parts Assembly see 6.1.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16 - 17 - 18

MIL-T-46605B

4.5.1  Lot.

4.5.1.1  Submission of product.  Unless otherwise specified by the contracting activity, formation and identification of lots shall be in accordance with MIL-STD-105.

4.5.1.2  Size of lot.  The production lot size shall be as specified in the contract.

4.5.2   Examination.   One  hundred  percent  examination  shall  be  performed  for  all  critical  defects. Examination  for  major  and  minor  defects  shall  be  performed  on  a  defect  basis  in  accordance  with  the classification of defects.  Four power (4x) magnification may be used in performing visual examination for such defects as burr and foreign matter.  Inspection for rubber O-rings shall be in accordance with MIL-STD-

413.   When compliance with the applicable requirement is in doubt as a result of visual examination, the

characteristic shall be measured or gaged to determine acceptability.  All nonconforming material shall be rejected.

4.5.2.1  Pin, Shear, Firing Pin, Drawing 10520486, covering a detail of Drawing 10520974.

4.5.2.2  Pin, Shear, Piston, Drawing 10520487, covering a detail of Drawing 10520974.

Critical

None defined

Major

101                               Diameter, max                                                                                      Gage

102                               Total length, min                                                                                  Gage

5