MIL-DTL-14804B(OS)
3.8 Workmanship. Assemblies shall be free of cracks, splits, or other defects which might prevent proper
mating with connecting parts or proper functioning of the device.
3.8.1 Metal defects. All components shall be free from cracks, splits, cold shuts, inclusions, porosity, or any
similar defect.
3.8.2 Burr. No part shall have a burr which might interfere with the assembly or function of the item or
which might be injurious to personnel handling the item.
3.8.3 Foreign matter. No part or assembly shall contain chips, dirt, grease, rust, corrosion, or other foreign
matter.
4. VERIFICATION
4.1 Quality assurance terms and definitions. Reference shall be made to ASQC A8402 to define the
quality assurance terms used.
4.1.1 Inspections. Inspections shall be in accordance with MIL-A-2550.
4.2 Inspection conditions. Unless otherwise specified (see 6.2), all inspections shall be performed under the
following conditions:
a.
Temperature: Room ambient (68 to 77 F)
b.
Altitude: Sea level
c.
Humidity: 50 percent relative, maximum
d.
Atmospheric pressure: 14.7 psi
4.3 Quality conformance inspection.
4.3.1 Lot.
4.3.1.1 Submission of product. Unless otherwise specified by the contracting activity, formation and
identification of lots shall be in accordance with ASQC Z1.4.
4.3.1.2 Size of lot. For the purpose of identification and shipment, the shipping lots of metal parts assemblies
shall consist of 1200 assemblies maximum, provided the homogeneity requirement of inspection lots have
been retained.
4.3.2 Examination. On reprocessed parts, one hundred percent examination shall be performed for all critical
defects. Examination for major and minor defects shall be performed in accordance with the classification of
defects, using the sampling plan and associated criteria specified in the contract (see 6.2 and 6.3). Four power
(4x) magnification may be used for inspection of such defects as burr and foreign matter. Inspection for
rubber O-rings shall be in accordance with MIL-STD-413. When compliance with the applicable requirement
is in doubt as a result of visual examination, the characteristic shall be measured or gaged to determine
acceptability. All nonconforming material shall be rejected.
4
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business