MIL-T-60801A
2.1.2 Other Government documents, drawings, and publications. The following Government drawings
form a part of this specification to the extent specified herein. Unless otherwise specified, the issues are those
cited in the solicitation (see 6.2).
DRAWINGS
Indian Head Division, Naval Surface Warfare Center (CAGE Codes 19200 and 19203)
10520974
Thruster, Cartridge Actuated, M13, Metal Parts Assembly
8836128
Box, Fiberboard (Inner), Packing, Ammunition, For Thruster, Cartridge Actuated,
M13 or M19
8836129
Box, Packing, Ammunition, For Thruster, Cartridge Actuated, M13 or M19
9217388
Box, Fiberboard (Outer), Alternative, Packing Ammunition, for Thruster, Cartridge
Actuated, M13 or M19
U.S. Air Force
TPO 00-756-3501
Thruster, Cartridge Actuated, M13
(Application for copies should be addressed to: Commander, Naval Surface Warfare Center, 101 Strauss
Avenue, Data Control Branch (Code 8410), Indian Head, MD 20640-5035.)
2.2 Order of precedence. In the event of a conflict between the text of this document and the references
cited herein, the text of this document takes precedence. Nothing in this document, however, supersedes
applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Materials. All materials used in the manufacture of the thrusters shall conform to the specifications
referred to on the respective drawings unless specific approval in writing covering a departure therefrom has
been obtained from the cognizant Navy design activity prior to manufacture. When alternate materials or
methods of manufacture are specified on the drawings, the bidder's selections shall be clearly stated in the
proposal. The remanufactured thruster metal parts assembly shall contain new shear pins, new O-rings, and
new setscrews (see 6.5).
3.2 Hydrostatic pressure. The body shall withstand a hydrostatic pressure of 11,500 pounds per square
inch (psi) for 15 seconds, minimum, without leaking, deformation, or mechanical failure (see 6.3.1).
3.3 Torque. Torque requirements shall be as specified in table I. No movement or deformation shall
occur upon application of the breakaway torque.
TABLE I. Torque requirements.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business