MIL-I-60281A
however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 Materials. All materials used in the manufacture of the initiators shall conform to the specifications referred to on the respective drawings unless specific approval in writing coveringa departure therefrom has been obtained from the cognizant Navy design activity prior to manufacture. When alternate materials or methods of manufacture are specified on the drawings, the bidder's selections shall be clearly stated in the proposal.
3.2 Components.
3.2.1 Primary components. For the purpose of this specification, the M91 impulse cartridge (Drawing8597230)isdefinedasaprimarycomponent. Onlyprimarycomponentsfromasinglelot shallbeusedinaproductionlotofinitiators;however,oneprimarycomponentproductionlotmay be used in more than one initiator production lot.
3.2.2 Component parts. AllcomponentpartsshallmeettheapplicablerequirementsofMIL-I-
82871 or MIL-I-60518 prior to assembly.
3.3 Breakaway torque. The chamber and cap of each assembled initiator shall withstand a breakaway torque application of 400 inch-pounds without loosening or deformation (see 4.3.1).
3.4 Residual magnetism. The initiator shall not deflect the indicator of the compass more than five degrees in either direction (see 4.3.2).
3.5 Radiographic examination. Each initiator assembly shall be radiographically examined for defects (see 4.3.3).
3.6 Functional.
3.6.1 Ballistics. Initiators loaded with cartridges from one accepted lot and temperature conditioned shall perform within the pressure values and delay times (see 6.4.1) specified in table I. Pressure values shall be recorded at the end of 15 feet of aircraft hose, assembly number MS28741-4, and a pressure chamber with a volume of 1 cubic inch.
3.6.1.1 Initiation. The initiator shall be fired by a source delivering an output pressure of 700 +25, !0 pounds per square inch gage (psig) at 70 ± 5EF.
3.6.2 Misfires. There shall be no misfires.
3.6.3 Mechanical failures. The initiator shall function without mechanical failure (see
6.4.2).
3
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business