MIL-D-60572B
TABLE I. Ballistic requirements.
Ignition delay time (sec)
Lower
Upper
Temperature (· F)
·60 to ·70
0.425
0.575
65 to 75
0.425
0.475
195 to 205
0.350
0.475
3.7 Workmanship. Delay elements shall be free of cracks, splits, or other defects which might prevent proper
mating with connecting parts or proper functioning of the device.
3.7.1 Metal defects. All components shall be free from cracks, splits, cold shuts, inclusions, porosity, or any
similar defect.
3.7.2 Burr. No part shall have a burr which might interfere with the assembly or function of the item or which
might be injurious to personnel handling the item.
3.7.3 Foreign matter. No part or assembly shall contain chips, dirt, grease, rust, corrosion, or other foreign
matter.
4. QUALITY ASSURANCE PROVISIONS
4.1 Responsibility for inspection. Unless otherwise specified in the contract or purchase order, the contractor
is responsible for the performance of all inspection requirements (examinations and tests) as specified herein.
Except as otherwise specified in the contract or purchase order, the contractor may use his own or any other
facilities suitable for the performance of the inspection requirements specified herein, unless disapproved by
the Government. The Government reserves the right to perform any of the inspections set forth in this
specification where such inspections are deemed necessary to ensure supplies and services conform to
prescribed requirements (see 6.2).
4.1.1 Responsibility for compliance. All items shall meet all requirements of sections 3 and 5. The inspection
set forth in this specification shall become a part of the contractor's overall inspection system or quality
program. The absence of any inspection requirements in the specification shall not
relieve the contractor of the responsibility of ensuring that all products or supplies submitted to the
Government for acceptance comply with all requirements of the contract. Sampling inspection, as part of
manufacturing operations, is an acceptable practice to ascertain conformance to requirements; however, this
does not authorize submission of known defective material, either indicated or actual, nor does it commit the
Government to accept defective material.
4.1.2 Quality assurance terms and definitions. Reference shall be made to MIL-STD-109 to define the
quality assurance terms used.
4